Controlling The Tv Via The Unit (When The Tv's Remote Control Sensor Is Blocked); Adjusting The Volume Level Of Each Channel (Ch Level) - Yamaha YSP-1400 Owner's Manual

Controlling the TV via the unit (when the TV's
remote control sensor is blocked)
When the TV Remote Repeater function is enabled, the unit receives TV remote control
signals at the TV remote control sensor (on front) and transmits the signals from the TV
Remote Repeater (on rear). This function is useful when you cannot operate your TV
from the remote control because the remote control sensor of the TV is blocked by the
unit.
NOTE
• This function is available only when your TV remote control uses infrared signals.
TV Remote Repeater
TV remote control
1
Turn on the unit.
2
Hold down the REPEATER key on the supplied remote control for
more than 3 seconds to enable/disable the TV Remote Repeater
function.
This completes the necessary settings. When the TV Remote Repeater function is
enabled, you can operate your TV from the TV remote control via the unit.
HINT
• The TV Remote Repeater function is disabled by default.
• If the power cable of the unit is connected to an AC wall outlet and when the TV Remote Repeater
function is enabled, the function is usable even when the unit is turned off.
• If you have made the unit learn the volume (+) operation (p.14), the volume of the TV may be turned
up when you turn up the volume of the unit with the TV remote control. In this case, follow Step 3 in
"Connections" (p.6) to change the TV setting.
• You can check the status of the TV Remote Repeater function by the center indicator when turning
on the unit.
TV's remote control sensor
Flash 3 times (enabled), Flash once (disabled)
Off (enabled), lights up (disabled)
Adjusting the volume level of each channel (CH
LEVEL)
The surround effects is achieved using six channels (audio outputs) of the unit. While
listening to a series of test-tones from the unit, you can adjust the volume level of each
channel to balance the sound heard from your listening position.
1
Hold down the CH LEVEL key on the remote control for more than 3
seconds.
The STATUS indicator flashes in green during test-tone output. The test-tone
cycles through the channels in the order below. The test-tone is output from each
channel in turn for two seconds. You can confirm which channel is playing the test-
tone by the way the indicators flash.
Test-tone flow
Front (left)
Center
Front (right)
Surround (right)
Surround (left)
Subwoofer
Back to beginning
➜
Continued
15