Yamaha Digital Sound Projector YSP-4300 Owner's Manual page 28

Initial settings
SYSTEM
MEMORY
Savingthisunit'ssettingstosystem
memo_
Three sets of settings can be saved to this unit's memory, enabling
quick loading of settings optimized for specific listeners or
environmental changes as needed. Refer to the examples below' to
save [ntelliBeam measurement results and settings such as
surround setting to system memory, or to load a pre-defined
settings.
The following settings can be saved to system memory.
• Surround playback (_ p. 33), stereo playback (_ p. 33), or
target playback rnode (_,_p. 33)
(The sound beam output method (_,_p. 36) can also be saved
for surround playback rnode.)
• [ntelliBeam measurernent results (_p. 23)
(When "HOR[ZONTAL ANGLE", "BEAM TRAVEL
LENGTH", "FOCAL LENGTH", and "IMAGE LOCATION"
are configured in the setup rnenu (_,_p. 58), these settings are
applied to IntelliBearn's AUTO SETUP measurements.)
• Surround: CINEMA DSP (_,_p. 34), surround decoder
(_ p. 38)
• Channel level (_:p. 33, 62)
• Tone control (_,:p. 43)
Example 1 Saving the IntelliBeam measurements for
different environments to system memory
[f materials that absorb sound, such as curtains, obstruct sound
beams, the effectiveness of those beams decreases. Measure with
the curtains open and again with them closed. Save both sets of
settings to system memory 1 and 2, and load the appropriate
settings as needed.
Example 2 Saving frequently used settings to system
memory
SYSTEM MEMORY 1: Surround
setting
SYSTEM MEMORY2:
A target playback mode setting that
projects sound beams toward the
kitchen
SYSTEM MEMORY 3: A target playback mode setting that
projects sound beams toward the living
room
Example 3 Saving preferred listener settings to system
memory
SYSTEM MEMORY 1: Settings configured for Dad
SYSTEM MEMORY 2: Settings configured for Morn
SYSTEM MEMORY 3: Settings configured for parties
28
En