Table of Contents
Advertisement
Schedule setting using Mouse
1.
Select a camera first and click on desired start time block (no number on it) on a time bar.
At this time, the selected time block will be highlighted in yellow frame and the entire
time bar will be highlighted by red frame.
2.
Click the desired start time block again to confirm, and this block (shows a new sequence
number on it) and all the following blocks will turn to gray. This means the grey time
blocks has been set to No Recording mode.
3.
To change the time blocks to different record mode (which shows a different color),
users need to click again on the block (with number on it) of any section. Every time the
user clicks the first block of a section, the color switches from gray->pink ->blue-green.
4.
Repeat the above steps to configure the record modes. You can configure up to six
record modes on each time bar.
Click the "Edit Timezone" button to edit the recording parameters for a time zone.
IP Camera:
Analog Camera:
Editing Timezone:
From: Displays time zone start time.
To: Displays time zone end time.
Record: Displays Record mode.
EMV401 / 801 / 1601 Hybrid Mobile DVR
123
Advertisement
Table of Contents
