Table of Contents
Advertisement
Home page
Using the Web UI
12
3004128-0001 Revision C
The Home page shows the current terminal status and allows
you to setup your initial data connection.
On the left side of the page is the Status bar. These items are
updated automatically when the status of any of these items
change.
1. Connection: This field indicates whether you are
Registered with the Network. It also shows the PS and CS
status, beam type and receive signal quality.
a. PS Attach Status: This field indicates whether you
are PS (Packet Switch) attached with the Network.
You will still need to setup a PDP context in order to
send PS data.
b. CS Attach Status: This indicates whether you are CS
(Circuit Switch) attached with the Network. Once you
are CS Attached and Registered with the network, you
are able to make CS calls.
2. GPS: This field displays the current GPS position status.
If you have received a GPS fix and the Network GPS
policy has been received and it allows the GPS position to
be shown to the user, it will display the Latitude,
Longitude, Fix Quality, and the Last time the GPS position
was updated. Time displayed is UTC time.
3. BGAN terminal: This field indicates the WLAN status.
4. Antenna Unit: This field indicates the detailed state of the
tracking antenna
a. The state field indicates the tracking state of the
antenna
b. Elevation: the current elevation look angle of the
antenna
c. The frequency of the global beam in MHz that the
antenna is attempting to track is displayed. If the unit
is experiencing problems, use the table below to verify
the antenna is searching for the correct satellite for
your location
The frequency is the frequency of the global beam.
Possible values are the primary and secondary frequencies
of the three satellites.
Advertisement
Table of Contents
