Button Lock - Suunto AMBIT3 RUN 2.0 User Manual

Off: The backlight is not switched on by pressing a button or
•
when the alarm clock sounds.
Night: The backlight turns on for a few seconds when you press
•
any button and when the alarm clock sounds.
Toggle: The backlight turns on when you press [Light Lock] and
•
stays on until you press [Light Lock] again.
Your Suunto Ambit3 Run has two backlight settings: one 'general'
setting and one for sport modes.
You can change the general backlight setting in the watch settings
under GENERAL » Tones/display » Backlight. See
settings . You can also change the general setting in Movescount.
You sport modes can use the same backlight mode as the general
setting (default), or you can define a different mode for each sport
mode under the advanced settings in Movescount.
In addition to the mode, you can adjust the backlight brightness (in
percent), either in the watch settings under GENERAL » Tones/
display » Backlight or in Movescount.
TIP: When the [Back Lap] and [Start Stop] buttons are locked,
you can still activate the backlight by pressing [Light Lock].

3.5 Button lock

Keeping [Light Lock] pressed locks and unlocks buttons.
2.3 Adjusting
17