Disable/Enable Event Logging - Avaya one-X 9610 Installation And Maintenance Manual

"1000 Mbps full" when PHY1STAT = 6
●
The PHY2STAT text strings are:
"Disabled" when PHY2STAT = 0
●
"Auto" when PHY2STAT = 1
●
"10Mbps half" when PHY2STAT = 2
●
"10Mbps full" when PHY2STAT = 3
●
"100Mbps half" when PHY2STAT = 4
●
"100Mbps full" when PHY2STAT = 5
●
"1000 Mbps full" when PHY2STAT = 6
●
2. To change the Ethernet setting, press the Right navigation arrow to cycle through the
possible settings.
Depending on the current value, the next sequential text string is selected and displayed as
the setting. For example, if the current value is 10Mbps half (2), pressing the Right
navigation arrow changes the value to 10Mbps full (3). If the current value is 1000Mbps full
(6), pressing the Right navigation arrow changes the value to Auto (1).
3. To change the PC Ethernet setting, select that line and press the Right navigation arrow to
cycle through the possible settings.
4. Press Save to store the new setting(s) and redisplay the Craft Local Procedure screen.

Disable/Enable Event Logging

Note:
When updating local (Craft) procedures from a 9670G IP Telephone, touching the
Note:
line you want to change or the applicable softkey produces the same result as
selecting a line and pressing the applicable softkey on other 9600 Series IP
Telephones.
Use the following procedure to enable or disable logging of system events.
1. When you select LOG from the Craft Local Procedure Screen, the telephone prompts you to
use the Right and Left navigation arrows to select a setting and displays the following text:
Log: text string
where, except for the 9610 which displays the actual value, the text string is the wording
associated with the current system value of NVLOGSTAT, defined as:
"Disabled" when NVLOGSTAT = 0
●
Disable/Enable Event Logging
Choice Selector
Issue 8 March 2012 45