Table of Contents
Advertisement
5.7 Handing Over
After completing the installation, commissioning and testing of the system, hand over to the
householder by the following actions.
1) Ensure the Installation and Service Instructions are left with the product.
2) Hand the User's Instructions to the householder and explain his or her responsibilities
under the current Gas Safety (Installation and Use) Regulations or the rules in force.
3) Hand over contact card to the User.
4) Advise the householder of the Electricity Supplier's requirements with respect to Small-
Scale Embedded Generators (SSEG) under
G83/1.
5) Explain and demonstrate the lighting and shutting down procedures and the function and
use of the product thermostat and controller.
6) Advise the householder on the efficient use of the system, including the use and
adjustment of all system controls for both domestic hot water and central heating.
7) Advise the householder of the precautions necessary to prevent damage to the system and
to the building, in the event of the system remaining inoperative during frosty conditions.
8) Explain the function of the product safety controls and how to reset them.
that if cut-out persists, the product should be turned off and a KD NAVIEN service
engineer consulted.
9) Make sure all safety labels are correct and in place.
10) Clean and remove all debris from around the site.
11) Send installation documentation to KD NAVIEN
Navien stirling engine m-CHP installation manual
National Regulations such as document ER
Emphasise
69 of 88
Page No:
Advertisement
Table of Contents
