Table of Contents
Advertisement
4.3 Mounting the appliance
This step can be delayed until immediately prior to system commissioning if site security
cannot be guaranteed. If this option is required, isolate the service connections and
continue with the system installation procedure described in the following sections, then
return to this section later.
Carefully check the security of the wall mounting plate before proceeding further.
4.3.1 Lifting Equipment
Before lifting work is processed, following requirement should be ensured.
1. Ensure that a visual inspection is carried out to asses for any obvious defects (such as
worn tyres, dents in equipment – noted by broken paintwork)
2. Check and remove any obstacles along the routes from where the appliance is, to where it
is to be installed.
3. Ensure all involved in the installation are aware that the lifting equipment is being used.
4. The height that the lifting kit raises the appliance must be kept to a minimum, only when
the back plate is ready should the appliance be raised on the lifting equipment.
5. Any house thresholds will need appropriate temporary ramps in place.
Lifting Equipment should comply with the following requirement.
- Weight allowed for lifting process should be at least + 200Kg
- The wheels must be locked during lifting process
- Ensure that balance is being sustained when carrying
4.3.1.1 Use of Lifting Gear
This process describes removing an NCM-1130HH appliance from a packaging box to the wall.
1) When you lift the appliance, do not get rid of the EPP bottom base.
2) Installation should be carried out by 2 people.
Navien stirling engine m-CHP installation manual
25 of 88
Page No:
Advertisement
Table of Contents
