Fujitsu AU*G07LVLA Technical Manual page 167

„ „
REMOTE CONTROLLER CUSTOM CODE SETTING
According to the following instructions, please set the custom code setting of the Wireless remote
controller to match any changes in the custom code setting of the indoor unit.
(Note that the air conditioner cannot receive a signal if the air conditioner has not been set for the
matching custom code.)
1. Press the Start/Stop "
the clock is displayed on the remote controller
display.
3. Press the "TEMP.
button to change the custom code between
"A"→"b"→"c"→"d".
● If no buttons are pressed within 30 seconds after the
returns to the original clock display. In this case, start again from step 1.
● The air conditioner
● The remote controller resets to
are replaced. If you use a custom code other than custom code "A", reset the custom code
after replacing the batteries. If you do not know the air conditioner custom code setting, try
each of the custom codes ("A"→"b"→"c"→"d") until you find the code which operates the air
conditioner.
" button until only
" or the "TEMP. "
custom code is set to "A" prior to shipment.
custom code "A" when the batteries in the remote controller
- (01-163) -
2. Press the "MODE" button for at least 5
seconds to display the current custom code
(initially set to "A").
4. Press the "MODE" button again to return to
the clock display. The custom code will be
changed.
custom code is displayed, the system