Fujitsu AU*G07LVLA Technical Manual page 162

„ „
REMOTE CONTROLLER CUSTOM CODE SETTING
According to the following instructions, please set the custom code setting of the Wireless remote
controller to match any changes in the custom code setting of the indoor unit.
(Note that the air conditioner cannot receive a signal if the air conditioner has not been set for the
matching custom code.)
1. Press the Start/Stop "
the clock is displayed on the remote controller
display.
3. Press the "TEMP.
button to change the custom code between
"A"→"b"→"c"→"d".
● If no buttons are pressed within 30 seconds after the custom code is displayed, the system
returns to the original clock indicator. In this case, start again from step 1.
● The air conditioner custom code is set to "A" prior to shipment.
● The remote controller resets to custom code "A" when the batteries in the remote controller
are replaced. If you do not know the air conditioner custom code setting, try each of the
custom codes ("A"→"b"→"c"→"d") until you find the code which operates the air conditioner.
" button until only
" or the "TEMP. "
- (01-158) -
2. Press the "MODE" button for at least 5
seconds to display the current custom code
(initially set to "A").
4. Press the "MODE" button again to return to
the clock display. The custom code will be
changed.