Quick Split Operation - Yaesu FT-2000 Operating Manual

Hf/50 mhz transceiver
Hide thumbs Also See for FT-2000:
Table of Contents

Advertisement

T
RANSMITTER
The Quick Split feature allows you to set a one-touch offset of +5 kHz to be applied to your radio's transmit
frequency on the Sub (VFO-B), compared to the Main (VFO-A) frequency.
1. Start with regular transceiver op-
eration on the Main (VFO-A) band.
MAIN (VFO-A)
[ RX ] switch "ON" (LED glows
Green)
[ TX ] switch "ON" (LED glows
Red)
SUB (VFO-B)
[ RX ] switch "OFF" (LED Off)
[ TX ] switch "OFF" (LED Off)
2. Press and hold in the [ SPLIT ] button for two sec-
onds to engage the Quick Split feature, and apply a
frequency 5 kHz above the Main (VFO-A) fre-
quency to the Sub (VFO-B) frequency register.
Press and hold in the [ SPLIT ] button for two sec-
onds to increment the Main (VFO-A) frequency to
+5 kHz.
The VFO configuration will then be:
MAIN (VFO-A)
[ RX ] switch "ON" (LED glows Green)
[ TX ] switch "OFF" (LED Off)
SUB (VFO-B)
[ RX ] switch "OFF" (LED Off)
[ TX ] switch "ON" (LED glows Red)
Q
P
:
UICK
OINTS
The operating mode applied to the Sub (VFO-B)
register will be the same as that in use on the Main
(VFO-A) register.
The offset of the Sub (VFO-B) from the Main VFO
(VFO-A) is programmed via the Menu, and is set
to +5 kHz at the factory. Other offsets may be se-
lected, however, using the following procedure:
1. Press the [ MENU ] button to enter the Menu mode.
2. Rotate the Main Tuning Dial knob to select Menu
item "031 gene Q SPLIT
031 gene Q SPLIT
031 gene Q SPLIT
031 gene Q SPLIT
031 gene Q SPLIT."
3. Rotate the [ SUB VFO-B ] knob to select the de-
sired offset.
The available selections are –20kHz
(factory default: +5 kHz
+5 kHz
+5 kHz
+5 kHz).
+5 kHz
4. When you have completed all adjustments, press
and hold in the [ MENU ] button for two seconds to
save the new setting and exit to normal operation.
If you only press the [ MENU ] button momentarily
to exit, any changes you performed will not be
stored.
FT-2000 O
PERATING
C
S
-F
PLIT
REQUENCY

Quick Split Operation

–20kHz ~ +20kHz
–20kHz
–20kHz
+20kHz
+20kHz
+20kHz
–20kHz
+20kHz
M
ANUAL
ONVENIENCE
O
PERATION
MAIN [ RX ] Switch
[ SPLIT ] Button
Main Tuning Dial Knob
F
EATURES
MAIN [ TX ] Switch
Sub [ RX ] Switch
Sub [ TX ] Switch
[ MENU ] Button
[ SUB VFO-B ] Knob
Page 77

Advertisement

Table of Contents
loading

Table of Contents