Installation Of The Optional Filter - Yaesu FT-2000 Operating Manual

I
NSTALLATION OF THE
1. Turn the front panel [ POWER ] switch "off," then turn
the rear panel's [ POWER ] switch "off."
2. Disconnect the all cables from the transceiver.
3. Referring to Figure 1, remove the three screws from
each side of the transceiver, and three screws from the
top edge of the rear panel. Slide the top cover toward
to the rear about 1/2 inch (1 cm), then remove the top
cover.
4. Refer to Figure 2 for the mounting location for the
optional filter. Position the filter so that its connectors
are aligned with the mounting pins on the board, and
push it into place.
5. Replace the top cover and its nine screws.
6. Filter installation is now complete. Now you must en-
able the newly-installed filter, using the Menu.
7. Connect the AC cable to the ~AC IN jack.
8. Turns the rear panel's [ POWER ] switch "on," then
turn the front panel [ POWER ] switch "on."
9. Press the [ MENU ] button momentarily to engage the
Menu mode.
10. Rotate the Main Tuning Dial knob to select the Menu
item "037 GEnE SUB FIL
037 GEnE SUB FIL 037 GEnE SUB FIL 037 GEnE SUB FIL." 037 GEnE SUB FIL
11. Rotate the [ SUB VFO-B ] knob to choose the selec-
tion appropriate for the filter you have just installed
("300 300" for YF-122CN, "500
300 300 300
12. Press and hold in the [ MENU ] button for two seconds
to save the new setting and exit to normal operation.
Page 128
O
PTIONAL
500" for YF-122C).
500 500 500
F
ILTER (YF-122C
F
IGURE
F
IGURE
FT-2000 O
YF-122CN)
OR
1
Optional Filter
RX-2 UNIT
RX-2 UNIT
2
M
PERATING ANUAL