Dvs Group; Keyer Group; 020 Tey Cw Mem1; 021 Tey Cw Mem2 - Yaesu FT-2000 Operating Manual

DISPLAY G
014 diSP QMB MKR
Function: Enables/Disables the QMB Marker (White ar-
row " ") to display on the Spectrum Band Scope when
the optional DMU-2000 Data Management Unit is con-
nected.
Available Values: On/OFF
Default Setting: On
A :
DVICE
If the optional DMU-2000 Data Management Unit is not
connected, this adjustment has no effect.
DVS G
015 dUS RX LVL
Function: Sets the audio output level from the voice
memory.
Available Values: 0 ~ 100
Default: 50
016 dUS TX LVL
Function: Sets the microphone input level to the voice
memory
Available Values: 0 ~ 100
Default: 50
FT-2000 O
PERATING
ROUP
ROUP
M
ANUAL
M
KEYER G
017 tEy BEACON
Function: Sets the interval time between repeats of the
beacon message.
Available Values: OFF/1 ~ 255 sec
Default Setting: OFF
018 tEy NUM STL
Function: Selects the Contest Number "Cut" format for
an imbedded contest number.
Available Values: 1290/AunO/Aunt/A2nO/A2nt/12nO/
12nt
Default Setting: 1290
1290: Does not abbreviate the Contest Number
AunO: Abbreviates to "A" for "One," "U" for "Two,"
"N" for "Nine," and "O" for "Zero."
Aunt: Abbreviates to "A" for "One," "U" for "Two,"
"N" for "Nine," and "T" for "Zero."
A2nO: Abbreviates to "A" for "One," "N" for "Nine,"
and "O" for "Zero."
A2nt: Abbreviates to "A" for "One," "N" for "Nine,"
and "T" for "Zero."
12nO: Abbreviates to "N" for "Nine," and "O" for
"Zero."
12nt: Abbreviates to "N" for "Nine," and "T" for
"Zero."
019 tEy CONTEST
Function: Enters the initial contest number that will in-
crement/decrement after sending during contest QSOs.
Available Values: 1 ~ 9999
Default Setting: 1
A :
DVICE
Press the [ CLEAR ] button to reset the contest number to
"1."

020 tEy CW MEM1

Function: Permits entry of the CW message for message
register 1.
Available Values: tyP1/tyP2
Default Setting: tyP2
tyP1: You may enter the CW message from the front
panel's Function Keys.
tyP2: You may enter the CW message from the CW
keyer.

021 tEy CW MEM2

Function: Permits entry of the CW message for message
register 2.
Available Values: tyP1/tyP2
Default Setting: tyP2
tyP1: You may enter the CW message from the front
panel's Function Keys.
tyP2: You may enter the CW message from the CW
keyer.
M
ENU ODE
ROUP
Page 113