Buzzer (Only Certain Models); Activating/Disactivating The Buzzer - Electrolux EDW 1500 - 1510 Service Manual

4.7 Buzzer (only certain models)

The buzzer sounds to indicate the end of cycle and in the event of an alarm condition.
The buzzer sounds three times at the end of the cycle, but switches off immediately if the door is opened.
If the user prefers to switch off the buzzer, it is necessary to press a combination of buttons.
4.7.1

Activating/disactivating the buzzer

1. Cancel any cycles that have been selected.
2. Press S0 to switch the appliance on (LD0, salt and rinse-aid LEDs).
3. Press buttons S2 and S3 at the same time until LEDs LD1, LD2 and LD3 begin to flash.
4. Press button S3: LEDs LD1 and LD2 switch off, while LD3 continues to flash.
The condition of the buzzer is indicated by the display: 1b buzzer on, : 0b buzzer off
5. Press button S3 again to disactivate/activate the buzzer
6. To store this operation in memory: press button S0 and switch the appliance off or wait 60 seconds, the
appliance is in selection mode.
SOI/TD - PR 11 599 36 01-86