Accessibility; To Access The Components From Above, First Remove The Worktop (Free-Standing Versions Only); To Access The Components Housed In The Base From The Front Of The Appliance (Free-Standing Versions); To Access The Components Housed In The Base From The Lower Section, Remove The Bottom Panel (If Featured) As Follows - Electrolux DIVA Series Service Manual

ACCESSIBILITY

1
1.1 To access the components from above, first remove the worktop (free-standing
versions only):
(a) Remove the two screws from the rear section.
(b) Push the top forwards and release.
1.2 To access the components housed in the base from the front of the appliance
(free-standing versions):
(a) Remove the 5 lower plastic hooks starting from one side.
(b) Open the door to free the plinth.
(c) Rotate it and extract it.
Foot support:
(d) Remove the 6 fixing screws and remove it paying
attention not to damage the external door.
1.3 To access the components housed in the base from the lower section, remove
the bottom panel (if featured) as follows:
(a) Remove the inner filters (see 3.1 and 3.2).
(b) Remove any residual water from the sump by
suction, so that it does not flow into the tub and the
pressure switch tubes, then lay the appliance on its
rear panel.
(c) Unscrew and remove the regulation screw from the
rear foot (built-in versions only).
(d) Remove the screws which secure the bottom panel
to the base).
(e) Release the built-in retaining elements placed on
the right and rear side: and remove the bottom
panel by sliding to the right.
SOI/TD
( d)
4/23
( a)
(c)
599 37 44-27