Modifying A Set Programme; Cancelling A Programme (Reset); Modifying A Programme; Interruption Of A Programme (Pause) - Electrolux EDW 1500 - 1510 Service Manual

4.5 Modifying a set programme

4.5.1

Cancelling a programme (reset)

To cancel a programme that has already started, proceed as follows:
1. Open the door carefully and press buttons S2 - S3 together: the LED corresponding to the cycle being
executed begins to flash
2. All the LEDs and the display switch off: the programme is now cancelled and the appliance returns to
the selection mode with the salt (if the regeneration has not been excluded, see 6.14) and rinse-aid
LEDs switched on.
4.5.2

Modifying a programme

1. Press the button of the new programme until the LED of the current programme starts flashing
2. The LED of the old programme switches off and the LED of the new one lights; simultaneously the
programme starts: the possible options are cancelled and must be selected again.
4.5.3

Interruption of a programme (pause)

Proceed as follows to interrupt a programme that has already started:
1. Press S0 to switch the appliance off
2. To re-start the cycle, press S0 again: The programme starts from the point at which it was interrupted.
3. If you open the door the cycle interrupts: re-closing it, the programme starts (after a brief delay) from the
point at which it was interrupted.
Important! If the appliance is switched off or if the door is opened for more than 30 seconds during
the drying phase, the cycle is considered to have been terminated after the regeneration phase;
when the appliance is switched on again, it returns to programme selection mode.

4.6 Power failure

The Power Failure function maintains the information relative to the cycle status even in the even of a power
outage; when the power supply is restored, the cycle resumes from the point at which it was interrupted.
If the power failure occurs during the drying phase, the cycle is considered to have been terminated after the
regeneration phase.
SOI/TD - PR 10 599 36 01-86