Options; In 1 Tablet; Extra Rinse (Rinse +); 1/2 Load - Electrolux EDW 1500 - 1510 Service Manual

Short 30 min
Q5
Q6 Heat plates
Q7 Glassware

4.3 Options

4.3.1

" 3 in 1 Tablet"

This option can be selected by pressing the corresponding button, and remains in memory until the same
button is pressed again. This option modifies the phases of the programme in order to optimize performance
when "3 in 1" detergent tablets are used:
variation of the duration of the programme and the temperatures required to dissolve the detergent
tablets.
reduction of water exchange (partial drain phases)
exclusion of introduction of rinse-aid
exclusion of regeneration / resin washing
4.3.2

Extra rinse (rinse +)

This option may be selected temporarily by pressing the button (if featured), or in "Service" mode. If this
option is set by the service engineer, it remains in memory until disactivated (see relative section).
This option adds one cold rinse (with pulse washing) with a duration of about 5 minutes.
4.3.3

"1/2 load"

The 1/2 load option optimizes the washing cycle when only a small load is placed in the appliance.
1/2 load button
•
When this button is pressed, certain parameters of the selected washing cycle are modified:
Exclusion of Pre-wash (if featured)
Reduction of the washing temperature
Reduction of the duration of the programme (up to 36 minutes)
Automatic 1/2 load
•
When this button is not featured on the control panel, certain programmes may feature automatic detection
of the half load. This system measures variations in the temperature during the initial heating phase. The
temperature and the duration of the wash are both reduced.
This option is not available in the following cycles: "Intensive", "Short 30 minutes", "Soak", "Heating plates"
and "Glassware".
4.3.4

"Sanitize"

This is a special option used to sanitize the dishes/cutlery. However, it is NOT compatible with the
"Glassware" programme.
During the final rinse, the temperature is maintained at 68° C for 10 minutes.
If used together with the SOAK option, the system performs a special sanitizing programme which lasts
approximately 46 minutes (1 hot rinse followed by 10 minutes at a constant temperature of 68° C)

4.4 Selecting a washing programme

MODELS WITH DIRECT SELECTION: to each button corresponds a specific programme
1. Close the door and switch the appliance on [S0]: the LED LD0, the salt LEDs (if the regeneration has not
been excluded, see 6.14) and rinse-aid light so as to indicate the selection mode
2. Press a button to select a programme:
The relative LED lights
The display shows the flashing time-to-end
The indicator LEDs of the phase of the cycle light
3. Within 3 seconds after the programme selection it is possible
to set the eventual option or the delayed start (if available)
4. Automatically, 3 seconds after the last pressure of a button, the cycle starts
On the display the time-to-end lights steady and the LED of the current phase is on
SOI/TD - PR
--
65 max 1
-- -- 1
--
45 2
8
--
⊗ ⊗ ⊗
-- -- --
⊗
-- --
⊗ ⊗
599 36 01-86
31
29
69