Cleaning And Maintenance; Replacing The Batteries; Defects And Malfunctions - Tunturi GO Bike R 30 User Manual

EN
1. Locate the C/F switch on the rear of the console.
2. Move the C/F switch to "C" to use Celsius (°C) as the default system of
measurement.
3. Move the C/F switch to "F" to use Fahrenheit (°F) as the default system of
measurement.
4. Remove the batteries from the rear of the console. Refer to the section

"Replacing the batteries".

5. Insert the batteries into the console to apply the changes.

Cleaning and maintenance

The equipment does not require special maintenance. The equipment does not
require recalibration when it is assembled, used and serviced according to the
instructions.
WARNING
– Do not use solvents to clean the equipment.
▪ Clean the equipment with a soft, absorbent cloth after each use.
▪ Regularly check that all screws and nuts are tight.
▪ If necessary, lubricate the joints.
Replacing the batteries
The console is equipped with 2 AA batteries at the rear of the console.
1. Remove the cover.
2. Remove the old batteries.
3. Insert the new batteries. Make sure that batteries match the (+) and (-) polarity
markings.
4. Mount the cover.

Defects and malfunctions

Despite continuous quality control, defects and malfunctions caused by individual
parts can occur in the equipment. In most cases, it will be sufficient to replace the
defective part.
1. If the equipment does not function properly, immediately contact the dealer.
22 BIKE R 30