Cleaning And Maintenance - Tunturi S25 User Manual

- Without any pulse signal for 6 seconds,
console will display "P".
- Pulse alarm will sound when current pulse is
over the target pulse.
- Rang: "0-60~220" BPM.
Explanation of buttons
Enter
- Press "Enter" button to select console
functions: Scan,Time, Dist, Cal, T.H.R.
- Confirm setting or selection.
- Push and hold for 3 seconds in, stop "Enter",
to reset: Time, Distance, Calories.
Up
- Setting the goal values.
Down
- Setting the goal values.
Opperation
Power on
- Press any key to power on the console when
being in sleep mode..
- Start pedalling to power on the console when
being in sleep mode.
Power off
Without any signal being transmitted into the
monitor for 4 minutes the monitor will enter
SLEEP mode automatically. ( Active training
data will be lost )

Cleaning and maintenance

The equipment does not require recalibration
when it is assembled, used and serviced
according to the instructions.
WARNING
• Do not use solvents to clean the
equipment.
- Clean the equipment with a soft, absorbent
cloth after each use.
- Regularly check that all screws and nuts
are tight.
- If necessary, lubricate the joints.
Lubrication (fig. F)
Lubrication is a highly important service activity
for the Sprinter bike S25.
This is absolutely essential, if the friction of the
brake system increases noticeably.
Increased friction is indicated by jerky
movement in higher resistance levels.
The need for re-lubrication depends to a great
extent on the resistance settings and hours of
use.
We recommend you apply one drop of the
lubrication only when you feel the movement
becomes too jerky.
WARNING
• Never apply more than one drop of oil
(silicone) each time, to avoid the brake
system will be lubricated too much and
therefore loses tension build-up
Defects and malfunctions
Despite continuous quality control, defects and
malfunctions caused by individual parts can
occur in the equipment. In most cases, it will be
sufficient to replace the defective part.
- If the equipment does not function properly,
immediately contact the dealer.
- Provide the model number and the serial
number of the equipment to the dealer. State
the nature of the problem, conditions of use
and purchase date.
17
English