Pulse (T.H.R.)
- Current pulse will display after 6 seconds
when detected by the console.
- Without any pulse signal for 6 seconds,
console will display "P".
- Pulse alarm will sound when current pulse is
over the target pulse.
- Rang: "0-60~220" BPM.
Explanation of buttons
Enter
- Press "Enter" button to select console
functions: Scan,Time, Dist, Cal, T.H.R.
- Confirm setting or selection.
- Push and hold for 3 seconds in, stop "Enter",
to reset: Time, Distance, Calories.
Up
- Setting the goal values.
Down
- Setting the goal values.
Opperation
Power on
- Press any key to power on the console when
being in sleep mode..
- Start pedalling to power on the console when
being in sleep mode.
Power off
Without any signal being transmitted into the
monitor for 4 minutes the monitor will enter
SLEEP mode automatically. ( Active training
data will be lost )
Cleaning and mainte-
nance
The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
WARNING
•
Do not use solvents to clean the
equipment.
•
Clean the equipment with a soft,
absorbent cloth after each use.
•
Regularly check that all screws and nuts
are tight.
•
If necessary, lubricate the joints.
Defects and malfunctions
Despite continuous quality control, defects and
malfunctions caused by individual parts can
occur in the equipment. In most cases, it will be
sufficient to replace the defective part.
- If the equipment does not function properly,
immediately contact the dealer.
- Provide the model number and the serial
number of the equipment to the dealer. State
the nature of the problem, conditions of use
and purchase date.
15
English