Machine Installation; Preparation For Installation; Electrical Connection; Water Supply Connection - ECM Barista A2 User Manual

4

MACHINE INSTALLATION

The installation is to be carried out exclusively by qualified specialists, according to the following
instructions and in compliance with valid laws.
The following chapters deal with the preparation of the machine, its electrical connection, water supply connection
and drainage connection.

4.1 Preparation for installation

• Place the machine on an even and stable surface. You can regulate the height by adjusting the feet
of the machine.
• Never place the machine on hot surfaces.

4.2 Electrical connection

• The electrical connection has to be conducted by authorised specialty dealers.

4.3 Water supply connection

Important
Make sure that the water supply installation is connected to a potable water supply with an operating
pressure with max 3 bars. In case of an operating pressure of more than 1.5 bars, use a pressure
regulator.
Please note that often the pressure of the water supply varies. If the water supply pressure temporarily
exceeds 1.5 bars, use a pressure regulator. Furthermore, a shut-off valve should be used. This valve
should be located where it is easily reached, so that the water supply can be interrupted at any time.
Water connection 3/8"
Important
Rotary pumps require pre-pressure. For this reason, they should always be connected to a fixed water
supply and not be used with an external, pressure-less water container. This could damage the pump.
4.4 Installation of the water drainage
The hose for the waste water is inserted into the appropriate L-connector at the bottom of the machine and the
already installed syphon drainage. Then the L-connector is screwed together with the drainage funnel. Please make
sure that the drainage hose is positioned in a manner that no water can accumulate in it.
Connecting the metal hose
18
Connection (wrench size 20)
ENGLISH