Parameter List (Master); Pedal/Gk Ctl - Roland GR-55 Owner's Manual

Parameter List (MASTER)

PEDAL/GK CTL

Tab Parameter
STATUS
(CTL, EXP SW
only)
CTL,
EXP SW,
GK S1,
FUNCTION
GK S2
Value Description
OFF, ON Switches the pedal on/off (reflects the indicator's illumination status).
Here you can specify the function that will be assigned to the [CTL] pedal, the expression pedal switch, or the GK [S1]/[S2] buttons.
OFF No function will be assigned to the above pedal or switch.
HOLD parameter
HOLD TYPE
HOLD
(CTL only)
SWITCH MODE
PCM TONE 1
PCM TONE 2
TAP TEMPO Sets the tempo to the timing at which you press the pedal.
Controls the on/off switch for each tone and the normal pickup.
TONE SW parameter
SW OFF
TONE SW
SW ON
AMP SW Switches AMP on/off.
MOD SW Switches MOD on/off.
MFX SW Switches MFX on/off.
DELAY SW Switches DELAY on/off.
REVERB SW Switches REVERB on/off.
CHORUS SW Switches CHORUS on/off.
Value Description
Notes that were sounding when you pressed the pedal
will be held, and successive notes that are played while
you continue holding down the pedal will also be held.
This differs from "HOLD TYPE 4" in that if a note is already
1
sounding on the same string, the previous note will be
silenced, and the note newly played on that string will take
its place. This allows you to play without a break even if the
note is on a distant fret.
Notes that were sounding when you pressed the pedal will
be held as long as you continue holding down the pedal.
2
Notes played after you started holding down the pedal will
not sound.
Notes that were sounding when you pressed the pedal will
be held as long as you continue holding down the pedal.
3
Notes played after you started holding down the pedal will
sound, but will not be held.
Notes that were sounding when you pressed the pedal will
4 be held, and successive notes that are played while you
continue holding down the pedal will also be held.
LATCH Hold will turn on/off each time you press the pedal.
MOMENT Hold will be on only while you hold down the pedal.
OFF, ON
Choose the "OFF" setting if you don't want the tone to be
held.
OFF, ON
Value Description
PCM TONE 1
OFF/ON
PCM TONE 2
These settings are for when the STATUS of each controller
OFF/ON
([CTL] pedal, expression pedal switch) is "OFF. "
GK S1/S2 are the settings for the default state (i.e., before
MODELING
you've pressed a switch).
TONE OFF/ON
NORMAL PU
OFF/ON
PCM TONE 1
OFF/ON
PCM TONE 2
These settings are for when the STATUS of each controller
OFF/ON
([CTL] pedal, expression pedal switch) is "ON. "
GK S1/S2 are the settings for when the switch has been
MODELING
pressed once.
TONE OFF/ON
NORMAL PU
OFF/ON
Patch Settings (MASTER)
55