Tuning Your Instrument (The Tuner Function) - Roland GR-55 Owner's Manual

Setting Description
B-AMP WITH Choose this setting if the GR-55 is connected to a bass
TWEETER amp that has a tweeter.
Choose this setting if the GR-55 is connected to a bass
B-AMP NO
amp that does not have a tweeter. The high-frequency
TWEETER
range will be corrected appropriately.
5. Press the [EXIT] button a number of times to return to the
top screen .
Tuning Your Instrument
(the Tuner Function)
Here's how you can use the GR-55's Tuner function to tune your guitar
or bass.
1. Press the [2] pedal and [3] pedal simultaneously .
The TUNER screen will appear.
2. Use the PAGE [ ] [ ] buttons to switch between the tabs to
choose the mode of the Tuner function .
Tab Description
MULTI MODE
Allows you to tune six strings at the same time.
Allows you to tune by playing a single note on the
SINGLE MODE
specific string you're tuning.
3. Play an unfretted note on the string that you want to tune,
and tune the string so that the desired note name is shown
in the display .
When using MULTI MODE
When using SINGLE MODE
* In SYSTEM parameter GK SETTING, if DOWN TUNE (p . 75) is set to a
value other than "0," the tuner screen will indicate the note names as
if they were not down tuned .
4. Watch the screen, and tune your instrument so that only the
center indicator is lit .
Repeat steps 3 and 4 until all of the strings are tuned.
MEMO
When tuning a guitar that's equipped with a vibrato arm, tuning
one string may cause other strings to drift out of tune. In this case,
start by tuning each string approximately, so that the correct note
name is shown, and then retune each string repeatedly until all
strings are tuned correctly.
5. When you've finished tuning, press a pedal (any one of the
[1]–[3] pedals or the [CTL] pedal) .
You will return to the original screen.
You can also return to the original screen by pressing the [EXIT] button.
Settings in the TUNER screen
In the TUNER screen you can use the cursor buttons and the dial to
make the following settings.
Parameter Value
435 Hz
MASTER TUNE
–445 Hz
OFF
TUNER MUTE
ON
Preparations for Using the GR-55
Description
Specifies the reference pitch.
* With the factory settings this is set to
"440 Hz . "
Sound will be output while you're tuning.
Sound will not be output while you're tuning.
* The factory setting is "ON . "
13