Cooling Fan And Thermal Fuse (Non-Resettable) - Electrolux FGES3065P series Service Manual

Figure 51
3. Remove two (2) screws securing cooktop to side
panels; one (1) on each side. See
Figure 52
4. Remove one (1) screw securing cooktop to rear
panel. See Figure 53.
Figure 53
5. Slide cooktop assembly forward and up to remove.
6. Reinstall in reverse order.
To remove a Surface Element:
1. Remove the Cooktop and Surface Element Assembly
(see "To remove the Cooktop and Surface Element
Assembly" on page 4-2).
2. Carefully place the Cooktop and Surface Element
Assembly glass down as shown in
3. Disconnect wires from Surface Element.
4. Press DOWN on the mounting bar, then move anchor
away from element. See
5. Reinstall in reverse order.
Figure 52.
Remove screw
(One (1) on each side)
Rear of Range
Figure 54.
Figure 55.
Section 4 Component Teardown
Figure 54
Figure 55
Bottom of Radiant Element
Anchor
Cooling Fan and Thermal Fuse (Non-
Resettable)
To access the Cooling Fan and Thermal Fuse:
1. Remove the Control Console (see
Control Console" on page
2. Remove the Cooktop and Surface Element Assembly
(see "To remove the Cooktop and Surface Element
Assembly" on page 4-2).
3. To remove the Cooling Fan, remove the two (2)
wires from the Fan Motor and rotate the Cooling Fan
assembly counter-clockwise to release locking tabs.
Lift to remove. See Figure
4. To remove the Thermal Fuse, remove two (2) wires
and two (2) screws securing the Thermal Fuse to the
Cooling Fan housing. See
5. Reinstall in reverse order.
Press DOWN on
Press DOWN on
Mounting Bar , Mounting Bar ,
then move Anchor
then move Anchor
away from element
away from element
Mounting Bar
Anchor
"To access the
4-1).
57.
Figure 57.
4-3