NEC NC1600C Service Manual page 248

FRAME1_C
Diagram symbol Circuit symbol
PRT1
PRT2
PRT3
PRT4
PRT5
PRT6
PRT7
PRT8
CAUTION : EMI (Electro Magnetic Interference : radio disturbance)
1 GASKET(STG0.5-8 ) should be 300mm/680mm each, and paste it on the FRAME ASSY.
2 GASKET(STG10-10) should be 90mm/270mm each, and paste it on the FRAME ASSY.
3 GASKET(STG7-10) should be 50mm/ 170mm each, and paste it on the FRAME ASSY.
4 GASKET(STG0.5-8) should be 280mm/ 680mm each, and paste it on the FRAME ASSY.
PRT6
PRT4
PRT2
PRT6
PRT2 pastes based on inner side.
PRT3 pastes along SCREW.
The right and left of PRT4 shall be stuck to the inside ends of each metal fitting. PRT4 in the center shall be stuck to the center.
PRT5 shall be stuck along the outside and based on the left red line over the head.
PRT6 shall be stuck so that it comes to the center between the front and rear screws.
PRT7 shall be stuck according to the vertical frame (light blue).
PRT8 shall be stuck according to the junction at the left end.
"Confidential, Do Not Duplicate without written authorization from NEC."
ASSEMBLY DIAGRAM
Part name
FRAME ASSY
GASKET(STG0.5-8)
GASKET(STG0.5-8)
GASKET(STG0.5-8)
GASKET(STG10-10)
GASKET(STG10-10)
GASKET(STG10-10)
GASKET(STG10-10)
PRT5
PRT4
PRT4
PRT5
9-8
Part code Q'ty
24HS4261 1
24C07561 1 680mm
24C07561 1 680mm
24C07561 3 300mm
24C05351 2 270mm
24C05351 2 90mm
24C05351 2 140mm
24C05351 2 30mm
PRT8
PRT7
PRT1
PRT3
PRT8
PRT7
Remarks