Self-Diagnosis Ii; Fault Table, Fault Codes 16485 - Skoda Octavia 1997 Workshop Manual

2.0 i/85kw engine, fuel injection and ignition systems
Hide thumbs Also See for Octavia 1997:
Table of Contents

Advertisement

OCTAVIA 1997
2,0 l/85 kW Engine, Fuel Injection and Ignition System
01-2

Self-diagnosis II

Fault table, fault codes 16485...17736

Note
The fault table is arranged according to the 5-digit
fault code on the left.
Faults related to the electronic throttle are indicated
on the dash panel insert by the fault lamp for the elec-
tronic accelerator control „EPC warning lamp".
The SAE code which is displayed on the right next to
the fault code (e.g.. P0107) can be ignored (at present
only valid for USA).
Explanations regarding fault types (e.g. „open circuit
or short-circuit to earth")
the vehicle system tester.
If parts are output as faulty: First of all, test all the ca-
bles and plug connections to these components as
well as the earth cables of the system according to the
current flow diagram. Replace the component only if
this test does not reveal any fault. This applies in par-
ticular if the fault is shown as sporadic (SP).
Note
16486 = Fault denomination
P0113 = next fault code (at present only applicable for
USA)
035 = fault type as number
air mass meter -G70- = current path or fault point de-
fective
Signal too small = designate fault type with text
sporadically occurring fault = fault which does not oc-
cur often, e.g. loose contact
Readout on
-V.A.G 1552 -
16485
Air mass meter -G70-
16486
Air mass meter -G70-
16487
Air mass meter -G70-
Edition 01.04
S00.5128.53.20
Operating instructions for
Rectifying fault
Implausible
Read measured value block, display group 002
signal
Check wiring to meter -G70-
Fault Finding and Fitting Locations
Signal too low
Testing the intake system for tightness (unmetered air)
Replace air filter element
Read measured value block, display group 002
Remove short-circuit or line interruption
Electrical Fault Finding and Fitting Locations
Replace engine control unit
Test fuse 43
Signal too
Read measured value block, display group 002
high
Test wiring
Fitting Locations
Replace engine control unit
Current Flow Diagrams, Electrical Fault Finding and
Self-diagnosis II
Chapter 01-5
Current Flow Diagrams, Electrical
Chapter 01-5
Current Flow Diagrams,
Chapter 24-4
Chapter 01-5
Chapter 24-4
01-2
01
1
page

Advertisement

Table of Contents
loading

Table of Contents