Troubleshooting - Panasonic KX-A406 Installation Manual

Note
R The repeater's Site Survey mode works independently from the CS. This means that the CS does not
have to be placed into Site Survey mode.
R When using more than 1 repeater in Site Survey mode simultaneously, please ensure repeaters are
set to different channels.
1
While pressing and holding down the PROGRAM button, turn on the repeater by connecting the AC
adaptor.
The STATUS indicator will flash red.
2
Continue to hold down the PROGRAM button for 5 seconds.
The STATUS indicator will flash red quickly.
Note
If you continue to hold down the PROGRAM button for 10 seconds, the repeater will enter
De-registration mode.
3
Release the PROGRAM button.
The STATUS indicator will flash red to indicate the current channel number, and a carrier sense will
start to check whether the current channel is available (idle) or not.
4
If the current channel is available, the STATUS indicator will change to flash green.
Site Survey mode on the current channel is now operational.
Note
A carrier sense is performed regularly in Site Survey mode. If the selected channel is not available
(busy), the STATUS indicator will flash red to indicate the channel number and the repeater will stop
transmitting.
5
Activate the site survey function on the PS to measure the radio signal strength level. The repeater
CSID is 1234567890.
Note
R It is recommended that the radio signal strength level is "03" or greater.
R For details about using the PS during a site survey, refer to the appropriate documentation for the
CS.
6
To change the site survey channel, press the PROGRAM button.
The channel number will change by one each time the PROGRAM button is pressed.
7
To turn off Site Survey mode, turn off the repeater by disconnecting the AC adaptor, and then turn on
the repeater by connecting the AC adaptor.

Troubleshooting

PROBLEM
R The repeater does
not turn on.
PROBABLE CAUSE
R The AC adaptor is not
connected properly.
1. Linking to Cell Stations
SOLUTION
R Make sure that the AC adaptor is properly
connected to both the repeater and the AC
outlet.
19