Troubleshooting - Panasonic KX-TGA405EX Installation Manual

TGA405EX(en).fm Page 4 Wednesday, August 22, 2012 10:39 AM

Troubleshooting

Problem
The unit does not work.
While talking using the
handset, sound cuts in and
out.
A repeating tone is heard
while talking using the
handset.
or
The & indicator continues
to light amber and the w
indicator flashes green.
Cause/solution
L When the indicators do not light, the AC adaptor is not
connected properly. Check the connections.
L When the indicators do not light green, move the unit closer to
the base unit.
L The repeater mode is "Off". Set the repeater mode to "On".
L Registration may have been cancelled.
Deregister the unit, then re-register.
Deregister:
1
Unplug the AC adaptor, then press and hold {PROGRAM}.
2
While pressing and holding {PROGRAM},
re-connect the AC adaptor.
3
Keep holding to press {PROGRAM} for about 10 seconds
until the & indicator stops flashing and lights red. Then
release {PROGRAM}.
L The & and w indicators light amber for a moment then
only the & indicator flashes red.
L If the & indicator flashes green after releasing
{PROGRAM}, deregistration failed. Deregister the unit
again.
Re-register:
1
DECT repeater: Unplug the AC adaptor.
2
Base unit: Press and hold {x} for about 5 seconds, until the
registration tone sounds.
L The next step must be completed within 90 seconds.
3
DECT repeater: Connect the AC adaptor, then wait until the
& indicator and w indicator light green.
4
Base unit: To exit the registration mode, press {x}.
L The registration tone stops.
L The handset is out of range. Move the handset closer to this
unit.
L {PROGRAM} was pressed. The unit is in programming mode.
To exit, press {PROGRAM} again. Do not press
{PROGRAM}, except when deregistering the unit.
– 4 –