Procedure Overview - Panasonic KX-A406 Installation Manual

Procedure Overview

When registering and installing the repeater, follow the procedure below to ensure smooth operation.
Registering the Repeater
Note
R Register repeaters one by one. Do not register multiple repeaters simultaneously.
R Do not disconnect the AC adaptor of any registered repeaters until the registration of all repeaters is
complete.
R After the registration of all repeaters is complete, proceed to the next step—"Installing the Repeater".
R Use only the supplied Panasonic AC adaptor.
R When connecting the AC adaptor to the repeater, press the plug firmly into the repeater for secure
connection.
a.
Place the unregistered repeater(s) (including cascade configuration repeaters) near the CS you are
attempting to register to.
b.
Turn on the repeater by connecting the AC adaptor.
c.
When registering to a CS:
The repeater is automatically registered to the CS in Easy Registration mode. For details about the
easy registration procedure, refer to "Easy Registration".
When creating a cascade configuration:
Each repeater in the cascade is automatically registered to the CS in Easy Registration mode when it
is turned on.
Then, in Manual Registration mode, register each cascade repeater to its destination repeater. For
details about the manual registration procedure, refer to "Manual Registration".
Installing the Repeater
a.
After all registration is complete, place the repeater where you want to install it.
b.
Turn on the repeater by connecting the AC adaptor.
The repeater enters Operation mode.
R If the STATUS indicator and the RSSI/ID indicator turn green (the radio signal strength level is
strong), the site is suitable for installing the repeater.
R If the RSSI/ID indicator turns amber or red (the radio signal strength level is weak or out of range),
turn off the repeater by disconnecting the AC adaptor. Then, move the repeater closer to the CS/
destination repeater, turn on the repeater again by connecting the AC adaptor, and confirm that
the RSSI/ID indicator turns green.
c.
Check whether the PS can be used at any location within the coverage area required by the user.
For details about conducting the site survey using a PS, refer to "Site Survey Mode".
1. Linking to Cell Stations
15