Table of Contents
Advertisement
Help
Troubleshooting
Indicator
Problem
The POWER indicator is
turned off.
The STATUS indicator is
turned off.
The STATUS indicator is
flashing in red.
The IN USE indicator
lights in green.
The IN USE indicator is
turned off when using the
sub monitor station.
Others
Problem
Can I register the
repeater to another main
monitor station?
Can I locate the repeater
in a place where the
STATUS indicator does
not light in green?
Can I locate the repeater
outdoors?
The repeater does not
improve the radio signal.
16
Cause & Solution
L T he power is not turned on. Connect the AC
adaptor.
L T he repeater has not been registered. Register it
to the main monitor station.
L T he power of the main monitor station is not
turned on. Turn it on.
L T he repeater is out of range. Install it in a
location where the STATUS indicator lights in
green.
L T he repeater is relaying radio waves.
L T he sub monitor station is being used in a place
where the radio signal is stronger from the main
monitor station than the repeater. (This is not
malfunction.)
Cause & Solution
L Y ou cannot register one repeater to two or more
main monitor stations. To register to another
main monitor station, another repeater is
needed.
L Y ou can install the repeater in a location where
the STATUS indicator lights in amber or red,
but sound cuts in and out, or calls may be
disconnected. We recommend a location where
the indicator lights in green.
L D o not install the repeater outdoors.
L T he STATUS indicator lights in amber or red,
or is flashing in red. Reinstall the repeater in a
location where the indicator lights in green.
L T he repeater has been installed near the main
monitor station. In this location, the repeater
cannot work effectively because the sub monitor
station receives radio waves from only the main
monitor station. Reinstall it in a location near to
where the sub monitor station is used.
Page
14
12
—
14
—
6
Page
—
14
—
14
6
Advertisement
Table of Contents
