Linking To Digital Cordless Phones; Linking To Digital Cordless Phones (Except For North America); Indicators; Installation/Registering The Repeater - Panasonic KX-A406 Installation Manual

3. Linking to Digital Cordless Phones

Linking to Digital Cordless Phones (except for North
America)
This section describes how to use the repeater to connect Panasonic Digital Cordless Phone base units
and handsets.

Indicators

Indicators
STATUS Green
Red
Off
RSSI/ID Green
Amber
Red
Off

Installation/Registering the Repeater

Once the repeater is connected to an AC outlet, it automatically goes into registration mode (if not
already registered).
IMPORTANT
R If the repeater is already registered, deregister the repeater first, then re-register it. For registering and
deregistering the repeater, refer to "Deregister" and "Re-register" in "Troubleshooting".
Note
R Use only the supplied Panasonic AC adaptor.
R When connecting the AC adaptor to the repeater, press the plug firmly into the repeater for secure
connection.
26
Light Status
On
Flashing
On
Flashing
On
On
On
R Within base unit range. The repeater is ready for use.
R Handsets are communicating with the base unit
through the repeater.
R Out of base unit range.
R The repeater is not registered to the base unit.
R The power is off. (AC adaptor is not connected
properly.)
R Signal strength of the base unit is strong.
R Signal strength of the base unit is weak.
R Out of base unit range.
R The repeater is not being used.
R The power is off.
Meaning