5 Troubleshooting
PROBLEM/QUESTION
•
The RSSI/ID LED does not
turn on.
•
The RSSI/ID LED flashes
red.
•
Can I register to more than
1 CM at the same time?
•
Can I install the repeater
where the RSSI/ID LED is
not green?
•
Can I install the repeater
outside?
•
Communication quality does
not improve after installing
the repeater.
20
PROBABLE CAUSE/ANSWER
•
The repeater is not registered.
→ Register the repeater.
•
The CM is not turned on.
→ Turn on the CM.
• The signal is too weak and the repeater is out
of range.
→ Install the repeater where the signal is
steady and the RSSI/ID LED is green or
amber.
•
You cannot register 1 repeater to more than
1 CM.
•
You can install the repeater where the
RSSI/ ID LED is red, but communication
may be unstable.
It is recommended to install the repeater
where the signal is steady and the RSSI/ID
LED is green or amber.
•
Do not install the repeater outside.
•
Is the RSSI/ID LED red or flashing red?
→ Re-install the repeater in an area where
the RSSI/ID LED is green or amber.
•
Is the repeater installed near the CM?
→ Installing the repeater near to the CM may
cause the All-In-One Headset or Belt
Pack to receive the signal directly from
the CM, making the repeater ineffective.
Re-install the repeater nearer to where
the All-In-One Headset or Belt Pack is
used.
PAGE
13
–
14
–
14
–
14
14