Hardware Installation; Power On Router; Factory Reset Button - D-Link DSL-G624T User Manual

Hardware Installation

The DSL-G624T maintains three separate physical interfaces, an ADSL, an Ethernet, and a wireless
interface. Place the Router in a location where it can be connected to the various devices as well as to a
power source. The Router should not be located where it will be exposed to moisture or excessive heat.
Make sure the cables and power cord are placed safely out of the way so they do not create a tripping hazard.
As with any electrical appliance, observe common sense safety procedures.
The Router can be placed on a shelf or desktop, ideally you should be able to see the LED indicators on the
front if you need to view them for troubleshooting.

Power on Router

CAUTION: The Router must be used with the power adapter included
with the device.
To power on the Router:
Insert the AC Power Adapter cord into the power receptacle located on the rear panel of the Router and plug
the adapter into a suitable nearby power source.
You should see the Power LED indicator light up and remain lit. The Status LED should light solid green
and begin to blink after a few seconds.
If the Ethernet port is connected to a working device, check the Ethernet Link/Act LED indicators to make
sure the connection is valid. The Router will attempt to establish the ADSL connection, if the ADSL line is
connected and the Router is properly configured this should light up after several seconds. If this is the first
time installing the device, some settings may need to be changed before the Router can establish a
connection.

Factory Reset Button

The Router may be reset to the original factory default settings by depressing the reset button (see illustration
on page 6) for a few seconds while the device is powered on. Use a ballpoint or paperclip to gently push
down the reset button. Remember that this will wipe out any settings stored in flash memory including user
account information and LAN IP settings. The device settings will be restored to the factory default IP
address 192.168.1.1 and the subnet mask is 255.255.255.0, the default management Username is "admin"
and the default Password is "admin."
DSL-G624T Wireless ADSL Router User Guide
7
2