D-Link DSL-G624T User Manual page 45

PPPoE and PPPoA Settings in detail
The example menu below is a section of the WAN settings for PPPoE and PPPoA connection types. Most
users will only need to enter a User Name and Password.
To configure a PPPoE or PPPoA type WAN connection, follow these steps:
1. If not already selected, choose the PPPoE/PPPoA option from the WAN Settings pull-down menu.
PPPoE/PPPoA is selected by default if you are configuring the Router for the first time.
2. Under the ATM VC Settings at the top of the window should not be changed unless you have been
instructed to change them. However, if you are instructed to change the VPI or VCI values, type in
the values assigned for your account. Leave the PVC and Virtual Circuit setting at the default
(Pcv0 and Enabled) values for now. This can be used later if you are configuring multiple virtual
circuits for your ADSL service. For more information on ATM VC Settings, see the table on page 42
below.
3. Under the PPPoE/PPPoA heading, type the User Name and Password used for your ADSL
account. A typical User Name will be in the form
assigned to you by your ISP or you may have selected it when you set up the account with your ISP.
4. Choose the correct Authentication Type from the drop-down menu. Most users will want to leave
the setting on Auto. PAP and CHAP are the other two options. The Auto setting will automatically
detect the correct type of authentication.
5. Choose the Connection Type from the pull-down menu located under the User Name and Password
entry fields. This defines both the connection protocol and encapsulation method used for your
ADSL service. The available options are PPPoA VC-Mux, PPPoA LLC and PPPoE LLC. If have not
been provided specific information for the Connection Type setting, leave the default setting.
DSL-G624T Wireless ADSL Router User Guide
PPPoE/PPPoA WAN settings section (enlarged view)
user1234@isp.co.au
37
. The Password may be