Table of Contents
Advertisement
Section 2 - Installation
Hardware Installation
A minimum of two Powerline devices (your DHP-1220AV and another pre-existing device or a DHP-W220AV) are required to
create a Powerline network.
Power
Plug the DHP-1220AV into an AC wall outlet where you want to extend your network and press the power button. The Power LED on the DHP-1220AV
will turn on to indicate it is receiving power. This may take up to 60 seconds.
Plug in the Ethernet Cable
Connect one end of the supplied CAT5 Ethernet cable to the Ethernet port on the DHP-1220AV and the other end of the cable to your Cable or DSL
modem's Ethernet port.
Connect to Your Existing Network
Press the Simple Connect Button on the DHP-1220AV for 3 seconds. Then, press the Simple Connect Button on the existing Powerline AV device
for 3 seconds. This must be done within two minutes after pressing the Simple Connect Button on the DHP-1220AV. The Powerline devices will
reboot. Read the installation advice on the next page, and continue to "Configuration" on page 12.
Note: Network connectivity is confirmed when the Powerline LED indicators on both Powerline devices are steadily lit. This will
indicate that your network is now secure.
ROOM A
ROOM B
ROOM C
DHP-1220AV
iPad
iPad
HomePlug
HomePlug
Internet
Modem
Notebook
Notebook
AV Device
AV Device
D-Link DHP-1220AV User Manual
9
Hide quick links:
Advertisement
Table of Contents
