Lexmark T630 User's Reference Manual page 271

Message
Queuing Jobs
Ready
Ready Hex
Reattach <device>
Remove Paper <specified
bin>
Res Reduced
Resetting Active Bin
Resetting
Maint Cnt Value
Resetting the Printer
Understanding the printer messages
What this message means
The printer is sending one or more
held jobs to print.
The printer is ready to receive and
process print jobs.
The printer is in Hex Trace mode and
is ready to receive and process print
jobs.
The specified device is either not fully
connected to the printer or is
experiencing a hardware failure.
<device>
is one of the following
• Output bin x, where x is 1–3
• Bins x - y, where x is 1–5, 2–6,
6–10
• Env Feeder
The specified output bin, or bins, is
full. The message would read as one
of the following:
• Remove Paper Standard Bin
• Remove Paper Output Bin x,
where x is the bin number
• Remove Paper All Output Bins
The printer is reducing the resolution
of a page in the current job from 600
dots per inch (dpi) to 300 dpi to
prevent a 38 Memory Full error. Res
Reduced remains on the display while
the job prints.
The printer is resetting to the active
bin in a linked set of bins.
The printer is resetting the counter
that tracks wear on the fuser.
The printer is resetting to the current
default settings. Any active print jobs
are canceled.
What you can do
Wait for the message to clear.
See also:
Hold function
Send a job to print.
• Send a job to print. All data sent
to the printer is printed in
hexadecimal and character
representation. Control strings
are printed, not executed.
• Turn the printer off and then on to
exit Hex Trace mode and return
to Ready status.
• Reestablish communication by
removing the specified device
and reattaching it to the printer.
: • Press Go to clear the message
and continue printing without
using the device.
• In the case of a hardware failure,
turn the printer off and back on. If
the error recurs, turn the printer
off, remove the specified device,
and call for service.
See also:
Remove the stack of paper from the
specified bin(s) to clear the
message.
Press Menu to open the Job Menu
and cancel the current job.
Wait for the message to clear.
Wait for the message to clear.
Wait for the message to clear.
See also:
panel to change printer settings
271
Using the Print and
Contacting service
Using the operator