Printer Language; Power Saver - Lexmark T630 User's Reference Manual

Select a menu item for more details:
Alarm Control
Auto Continue
Display Language
Download Target
Jam Recovery
Job Accounting
Page Protect
Note: Values marked by an asterisk (*) are the factory default settings.

Printer Language

Purpose:
To establish the default printer language used to communicate data from the computer to the printer.
Values:
PCL Emulation*
PS Emulation
Note: Setting a printer language as the default does not prevent a software application
from sending print jobs that use the other language.

Power Saver

Purpose:
To specify the amount of time (in minutes) the printer waits after a job is printed before it goes into a
reduced power state.
Values:
Disabled Disables Power Saver; the fuser remains warm and ready to print at all times.
1...240 Specifies the amount of time after a print job before the printer goes into
Power Saver mode. (Your printer may not support the entire range of values.)
The factory default Power Saver setting depends on your printer model. Print the menu settings page
to determine the current Power Saver setting. When the printer is in Power Saver mode, it is still
ready to receive print jobs.
Select 1 to put the printer in Power Saver mode one minute after it finishes a print job. This uses
much less energy, but requires more warm-up time for the printer. Select 1 if your printer shares an
electrical circuit with room lighting and you notice lights flickering.
Using the printer menus
Power Saver
Print Timeout
Printer Language
Resource Save
Staple Alarm
Toner Alarm
Wait Timeout
PCL emulation, compatible with Hewlett-Packard printers.
PostScript emulation, compatible with Adobe PostScript language.
236