Lexmark Printer User Manual page 196

Table 3-22: Variables for Flash and Disk File and Password Commands (Continued)
Parameter Syntax
START =
Note:
LOPENFILE Command
Use this command to open a file on a storage device.
Syntax:
LCLOSEFILE Command
Use this command to close a file on a storage device. The command is ignored if the
file doesn't exist on the device or if the file is not open.
Syntax:
Description
The location in the file to begin writing or reading. Use an integer that
represents an offset in bytes from the beginning of the file.
Optional for both LREADFILE and LWRITEFILE commands. If omitted on an
LREADFILE command,
omitted on an LWRITEFILE command with an
of
If a START location is provided but it is greater than the file size, the
LREADFILE command response will contain no file data. Similarly, an
LWRITEFILE command with an
LWRITEFILE command with an
If PostScript emulation is used to create the file on the device, it may
automatically attach a
Extensions" on page 6-10 for more information. For example, if
downloaded to flash through PostScript emulation, the
commands is
3-89
of (beginning of the file) is assumed. If
is also assumed.
extension to the
.
PJL
of ,
of functions like an
of .
. See "Filename
is
on the PJL