Default Command - Lexmark Printer User Manual

DEFAULT Command

This command modifies the default setting for the specified environment variable and
stores the setting in the printer NVRAM. The new setting is activated with the
occurrence of the next PJL reset condition.
Syntax:
The
to be modified. The variables supported are listed in the tables beginning on
page 3-12.
•
A
the tables "Common Variables for Both Printer Languages" on page 3-12,
and "Printer Unique Variables for Both Printer Languages" on page 3-19.
•
is used with variables specific to PCL emulation. (See the tables
"Common Variables for PCL Emulation" on page 3-48, and "Printer Unique
Variables for PCL Emulation" on page 3-49.)
•
the tables "Common Variables for PostScript Emulation" on page 3-51, and
"Printer Unique Variables for PostScript Emulation" on page 3-52.)
•
"
variables. (See the table "Printer Unique LRESOURCE Variables" on
page 3-53.)
Values for "
3-8
parameter specifies the type of PJL variables
parameter is not required for variables listed in
is used for variables specific to PostScript emulation. (See
" is required for LRESOURCE
" are:
, , , or
A unique identifier for a file, such as the macro ID for a PCL
macro, the symbol set ID for a PCL symbol set, the font ID
for a PCL font, and so on. The
An identifier that categorizes the file, such as
PCL macros or
"Table 3-22: Variables for Flash and Disk File and
Password Commands" on page 3-87 for a complete list of
the supported file types. The
PJL
(case insensitive)
is case sensitive.
for PCL symbol sets. See
is case sensitive.
for