Resetting To Factory Settings - Lexmark Prospect Pro200 Series User Manual

When Eco-Mode is enabled, the printer automatically switches to the following settings:
•
The printer display is dimmed.
•
The printer changes to Power Saver mode after ten minutes.
•
The printer prints on both sides of the paper (duplex) for copy and fax jobs, and for printing in Windows and Mac
OS X 10.6 or later (selected models only).
To enable Eco-Mode, press the 2-Sided/Eco-Mode button until the light near "Eco-Mode" comes on.

Resetting to factory settings

Resetting to factory default settings will delete all the printer settings you have previously selected.
Using the printer control panel menus
1
From the printer control panel, press
2
Press the up or down arrow button to scroll to Defaults, and then press
3
Press the up or down arrow button to scroll to Set Defaults, and then press
4
Press the up or down arrow button to scroll to Use Factory, and then press
5
When prompted to set the initial settings of your printer, make your selections using the printer control panel
buttons.
Initial Setup Complete appears on the display.
Using a button combination (if you cannot read the current language)
1
Turn off the printer.
Note: If you have set the Power Saver timeout in the Setup menu, then press and hold
off the printer.
2
From the printer control panel, press and hold
Note: Do not release
has been reset.
3
When prompted to set the initial settings of your printer, make your selections using the printer control panel
buttons.
Initial Setup Complete appears on the display.
.
and until Language Selection appears on the display, indicating that the printer
Using the printer control panel buttons and menus
and , and then press and release
20
.
.
.
for three seconds to turn
to turn the printer on.