Understanding Printer Messages - Lexmark C912 User Reference Manual

Message
Check <device>
Connection
Clearing Job
Accounting Stat
Close Front Door
Close Side Door
Close Top Door
Close Tray <x>
Top Cover
Copying
Defragmenting
Delete All Jobs
Deleting Jobs
Did You Replace
Belt?

Understanding printer messages

What this message means
The specified device is either not
fully connected to the printer or is
experiencing a hardware failure.
The printer is deleting all job
statistics stored on the hard disk.
The printer front door is open.
The printer side door is open.
The printer top door is open.
The high capacity feeder door is
open.
Note: The high capacity feeder
can only be installed as Tray 3 or
Tray 5.
The printer is processing a copy
job originating from the scanner.
The printer is defragmenting the
flash memory to reclaim storage
space occupied by deleted
resources.
The printer is requesting
confirmation to delete all held
jobs.
The printer is deleting one or
more held jobs.
You have turned on the printer
while the transfer belt is in the
warning state and needs to be
replaced.
Understanding printer messages
95
What you can do
• Reestablish communication by
removing the specified device and
reattaching it to the printer.
• Press Go to clear the message
and continue printing.
• If a hardware failure, turn the
printer off and back on. If the error
recurs, turn the printer off, remove
the specified device, and call for
service.
Wait for the message to clear.
Close the printer front door to clear
the message.
Close the printer side door to clear
the message.
Close the printer top door to clear
the message.
Close the top cover to clear the
message.
Wait for the message to clear.
Wait for the message to clear.
Warning: Do not turn the printer off
while this message is displayed.
• Press Go to continue. The printer
deletes all held jobs.
• Press Stop to cancel the
operation
Wait for the message to clear.
• Press Select to reset the transfer
belt maintenance counter.
• Press Stop to continue. The
message continues to appear
each time you turn the printer on
while the transfer belt is in the
warning state.