Software Does Not Install - Lexmark 9500 Series User Manual

D
ISCONNECT AND RECONNECT THE POWER CORD
1
Disconnect the power cord from the wall outlet, and then from the printer.
2
Plug the cord all the way into the power supply on the printer.
3
Plug the cord into a properly grounded electrical outlet that other electrical devices have been using.
4
If the light is not on, press

Software does not install

These are possible solutions. Try one or more of the following:
C
HECK YOUR OPERATING SYSTEM
The following operating systems are supported: Windows Vista, Windows XP, Windows 2000, and Mac OS X versions
10.34 and 10.4 (not versions 10.0, 10.1, or 10.2).
Note: Windows 2000 users should use Service Pack 3 or later.
C
HECK YOUR SYSTEM REQUIREMENTS
Check that your computer meets the minimum system requirements listed on the printer box.
C USB
HECK CONNECTION
1
Check the USB cable for any obvious damage.
2
Firmly plug the square end of the USB cable into the back of the printer.
3
Firmly plug the rectangular end of the USB cable into the USB port of the computer.
The USB port is marked with the
C
HECK WIRELESS CONNECTION
Check that the Wi-Fi indicator light is on. For more information, see "Understanding the parts of the printer" on
page 22.
2
.
USB symbol.
Troubleshooting
188