Nokia NSM–3 Service Manual page 225

PAMS Technical Documentation
Base offset edit box:
+/– buttons (+/– and left/right cursor keys):
Save button (ENTER):
Cancel button (ESC):
When selections are used, the power value checking is made and if it is
not successful, error message is shown. The test checks that all power
coefficients are in descending order (same order than power levels).
If the power tuning function is ended and EEPROM values are not re-
ceived or EEPROM fault is noticed, an error message is shown.
When all power coefficients have such values that they don't cause any
error messages, they can be saved. The last used tuning power is in use
after exit.
The next automatic selection is made when this tuning function is ended:
When dialog is closed original band is selected.
Issue 4 02/2002
This edit box shows the base offset value that the user can
change. The base level calculation check box must be checked
before this value is used. After this value is changed the user
must do the calculation.
NOTE: Do not use Enter button to accept this value.
+ and – buttons will cause power changing by 0.25dB steps.
When these keys are used the coefficient value is updated on
the tuning window.
Dialog is closed and tuned values are saved to phone. Base
offset is saved to TESLA.INI.
Dialog is closed and tuning is not saved to phone.
Operation Mode = RX pulsed
E Nokia Mobile Phones Ltd.
NSM–3/3D
Service Software Instructions
Page 35