Nokia NSM–3 Service Manual page 154

NSM–3/3D
Service Software Instructions
message in a few seconds, the the user is informed by special info win-
dow, where the user is asked to turn the power on and then press the re-
turn key.
Note also that power–off test (if passed) turns power off and power
should be reconnected by using the phones keypad after the successful
test. After the power has been connected to phone, the normal start–up
routines are made and the self–test results are shown in the MCU self–
tests menu (i.e. all other than power–up self–tests are in Not executed
state after the power–up routines).
Run button (ALT+R):
Run All button (ALT+A):
Supported Self Tests
1 MCU ROM Checksum................
2 MCU RAM Interface...............
3 MCU RAM Component...............
4 MCU EEPROM Interface............
5 MCU EEPROM Component............
6 RTC Battery.....................
7 CCONT Interface.................
8 A/D Converter...................
9 SW Reset........................
A Power Off.......................
B Security Data...................
C EEPROM Tune Checksum............
D PPM Checksum....................
E MCU Download DSP................
F DSP Alive.......................
G COBBA
Page 46
the user can select desired test from list and hit Run button.
When the user selects test to be run the text RUNNING... is
shown in test state field and test is run. When results are re-
ceived the test state field is updated according to the result.
If no response was received in the defined time, a error mes-
sage box will be shown and the test state is changed to No re-
sponse . Phone is set to local mode if it is not already.
the user can run all listed tests. The text RUNNING... is shown
in test state field and the test is run. When results are received
the test state field is updated according to the result. When
State field is updated the application moves to the next test
and repeats the previous cycle. The phone is set to local mode
if it is not already there.
Serial.......................
E Nokia Mobile Phones Ltd.
PAMS Technical Documentation
Issue 4 02/2002