Ps Menu - TallyGenicom 9040 User Manual

Menu Item
Spooling
Start Spooling
Destination
USB Setup
Interpreter
Format
Delay Out Close
Binary PS

PS Menu

The PS menu allows you to Print PS Errors. Items available in this menu are described below
Parameter
Print PS Errors
User Guide
Value Default
Start Spooling Destination
Destination
Off Off
Spool and
Print
Spool Only
User Flash User Flash
Disk
Auto Switch Auto Switch
PCL
PostScript 3
Raw Raw
Normal
Binary
On/Off Off
On/Off On
Value Default
On/Off Off
Operator Panel Menus
Description
The spooling feature allows print jobs to be
automatically spooled to the Flash memory.
This is a diagnostic tool.
As the flash memory is limited in size under
some circumstances the hard drive may be
required.
This item allows you to set up the USB
interface.
Configures how incoming print jobs are
scanned for special binary control codes.
RAW=no processing
Normal = "Adobe Standard Protocol" (ASP)
Binary = "Binary Control Protocol" (BCP)
When Interpreter setting is Auto Switch and
this setting is Raw, the printer will
automatically determine the control code
method, defaulting to Normal if no codes are
found.
When ON, the printer will wait until the job
is completely printed and delivered to the
output tray before terminating the
connection, allowing all reverse-channel
data to be sent back to the host. This will
cause a reduction in printer throughput.
When OFF, reverse-channel data generated
after the job interpretation is discarded. No
reduction in printer throughput occurs.
When On, the feature allows all binary codes
to be processed by the PostScript interpreter.
When Off, special binary control codes may
be intercepted per the Format item setting.
Description
Choose to either print or not print PS errors.
Operator Panel
3-13