Printer Receives A Blank Fax - Lexmark 7300 Series User Manual

Check the Dial Prefix setting.
1
From the control panel, press Fax Mode.
2
Press .
3
Press or repeatedly until Send Setup appears.
4
Press .
5
Press or repeatedly until Dial Prefix appears.
6
Press .
7
To change the setting, press
8
Press .
9
Enter the prefix to be dialed before each telephone number.
10
Press .
If you used a Speed Dial button:
•
Check to make sure it has been programmed for the number that you wish to dial. See "Setting up Speed Dial
numbers" on page 55.
•
As an alternative, dial the telephone number manually.
Make sure the printer is detecting a dial tone.
•
See "Sending a fax while listening to a call (On Hook Dial)" on page 52.
•
Check the Dial Method setting.
1
Listen for a dial tone. If you hear a dial tone but the printer hangs up without dialing, this means it did not
recognize the dial tone.
2
From the control panel, press Fax Mode.
3
Press .
4
Press or repeatedly until Send Setup appears.
5
Press .
6
Press or repeatedly until Dial Method appears.
7
Press .
8
Press or repeatedly until the method you want appears.
9
Press to save this setting.

Printer receives a blank fax

Ask the sender to verify the original document was loaded correctly.
Check the ink levels, and install a new print cartridge if necessary.
or repeatedly until Create appears.
89