Ir Connection - Russound X5 Installation Manual

IR CONNECTION

Common IR Output
The common IR output is supported by the IR engine and programming
tool in SCS. This comprehensive list of universal source codes and learning IR
capabilities supports the controller features built into the X5. They are also
carried by the keypad IR receiver and allows for use of the USRC hand held
remote control. There is an IR receiver located on the front panel of the X5 for
learning IR commands. See SCS software for more details on setting universal
12V Trigger Cable
12V Trigger Cable
38
D250LS Amplifi er
Russound X5 Controller Streamer Amplifi er Installation Manual
codes, learning commands or building Macros to control source devices
connected to the X5.
Attach the end of the IR emitter with the 3.5mm plug to the IR emitter
port. Remove the adhesive back at the other end of the emitter and attach
the emitter over the source component's IR window. In order to control the
connected source component with IR, the source must be selected at the
keypad or the app receiving the command. See the diagram below.
IR emitter
Russound
845.1
857
Connecting
Block