Source Audio Connection - Russound X5 Installation Manual

Bluetooth Audio Sensing
The X5 Bluetooth connection can be set to enable a feature that overrides
the last source selected when a Bluetooth audio signal is sensed. The feature
will require that a BTC-1X is connected. The BTC-1X must be paired to a hand-
held Bluetooth device and the X5 be programmed using the SCS programming
software tool. To enable the feature, open the SCS programming tool to the X5
Settings page.
CAT-5 Keypad Wire Color Type
Brown............................................+12V
Brown/White ..............................+12V
Green ............................................L -
Green/White ...............................L +
Orange .........................................R -
Orange/White ............................R +
Blue ................................................COM A
Blue/White ..................................COM B
Russound X5 Controller Streamer Amplifi er Installation Manual
When both the Bluetooth sensing and digital audio input sensing are enabled,
the X5 will determine the audio signal by a last source sensed approach. For
example, if you are watching TV and you decide to stream Bluetooth audio
to the BTC-1X transceiver, the X5 will switch from the TV audio signal to the
Bluetooth audio signal automatically when the feature is enabled. When the
Bluetooth audio signal isn't present, the X5 will revert to the previous state
which was the TV digital audio signal in this case. Disabling the feature
requires the user to select the Bluetooth source input on the keypad or My
Russound App and then push audio to the BTC-1X from the device. If no music
is playing from the hand-held Bluetooth device, the X5 zone will be quiet when
the Bluetooth source input is selected. It will not automatically switch back
to the previous source state when sensing is disabled. Disabling the feature
will also avoid automatic switching from a Bluetooth audio connection made
from a phone call. It is recommended, if using a phone to stream audio, that
you disable the feature so that phone calls won't automatically interrupt the
previous state of the X5.
CAT-5e Cable
Cable length - 300' (CAT-5) BTC-1X to X5
SOURCE AUDIO CONNECTIONS
BTC-1X
35