Save Configuration; Reboot System; Factory Default - ZyXEL Communications XS1920 Series User Manual

39.2.5 Save Configuration

Click Config 1 to save the current configuration settings permanently to Configuration 1 on the
Switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration
changes to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.

39.2.6 Reboot System

Reboot System allows you to restart the Switch without physically turning the power off. It also
allows you to load configuration one (Config 1) or configuration two (Config 2) when you reboot.
Follow the steps below to reboot the Switch.
In the Maintenance screen, click the Config 1 button next to Reboot System to reboot and load
1
configuration one. The following screen displays.
Figure 231 Reboot System: Confirmation
Click OK again and then wait for the Switch to restart. This takes up to two minutes. This does not
2
affect the Switch's configuration.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.

39.2.7 Factory Default

Follow the steps below to reset the Switch back to the factory defaults using the web configurator.
See Section 3.4 on page 29
up your current configuration before resetting.
In the Maintenance screen, click the Factory Default button to clear all Switch configuration
1
information you configured and return to the factory defaults.
Chapter 39 Maintenance
to reset the Switch using the Reset button. It is recommended to back
XS1920 Series User's Guide
322