ZyXEL Communications XS1920 Series User Manual page 36

Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION
Loop Guard This link takes you to a screen where you can configure protection against network loops
that occur on the edge of your network.
Layer 2 Protocol This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling)
Tunneling settings on the Switch.
PPPoE This link takes you to a screen where you can configure intermediate agent settings in
port, VLAN, and PPPoE.
Errdisable This link takes you to a screen where you can configure errdisable settings in CPU
protection, errdisable detect, and errdisable recovery.
MAC Pinning This link takes you to a screen where you can configure MAC pinning. If you are connecting
to multiple upstream switches that do not support port channels, then use MAC pinning to
divide the uplinks into standalone links that pins the MAC addresses to those links in a
round-robin method.
Private VLAN This link takes you to a screen where you can configure private VLANs.
Green Ethernet This link takes you to a screen where you can configure green Ethernet settings in EEE,
auto power down, abd short reach for each port.
LLDP This link takes you to a screen where you can configure LLDP settings.
IP Application
Static Routing This link takes you to a screen where you can configure static routes. A static route defines
how the Switch should forward traffic by configuring the TCP/IP parameters manually.
DiffServ This link takes you to screens where you can enable DiffServ, configure marking rules and
set DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to screens where you can configure the DHCP settings.
ARP Setup This link takes you to screens where you can configure the ARP learning settings for each
port.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password and
configure SNMP and remote management.
Diagnostic This link takes you to a screen where you can view system logs and test port(s).
Syslog This link takes you to screens where you can setup system logs and a system log server.
Cluster This link takes you to screens where you can configure clustering management and view its
Management status.
MAC Table This link takes you to a screen where you can view the MAC addresses (and types) of
devices attached to what ports and VLAN IDs.
IP Table This link takes you to a screen where you can view IP, VLAN ID and port information.
ARP Table This link takes you to a screen where you can view the MAC addresses – IP address
resolution table.
Routing Table This link takes you to a screen where you can view the routing table containing,
destination, gateway, interface, metric and type (static or dynamic) information.
Path MTU Table This link takes you to a screen where you can view the path MTU aging time, index,
destination address, MTU, and expire settings.
Configure Clone This link takes you to a screen where you can copy attributes of one port to other ports.
Neighbor Table This link takes you to a screen where you can view the IPv6 neighbor table which includes
index, interface, neighbor address, MAC address, status and type.
Chapter 4 The Web Configurator
XS1920 Series User's Guide
36